C Coatwell Commercial Roof Restoration
Minneapolis, MN · 55401 Silicone · Acrylic · Urethane · SPF

TPO Roof Restoration in Minneapolis, MN Near Me

Cleaning, seam repair and coating for chalking or shrinking TPO membranes before they reach the point of full replacement.

TPO Roof Restoration in Minneapolis, MN
Call us
(833) 441-4944
Silicone Roof Restoration
Metal Roof Coating
Moisture Scans Before Coating
Written Scope of Work
Recoat Instead of Tear-Off

TPO roof restoration is how we buy an aging single-ply roof more years. A TPO membrane in Minneapolis, MN wears in a predictable way: the top ply chalks and thins in the sun, seams start to open at the welds, and flashings pull away at curbs and walls.

Timing is everything. If the scrim is showing through the membrane, the roof is close to the end and a coating is a gamble. If the membrane is still sound, we can clean it, re-weld or tape failed seams, re-secure flashings and apply a coating system rated for TPO.

TPO is slick. Coatings do not want to stick to it without the right primer, so we do an adhesion test patch on your roof before we commit. That test tells us which primer and top coat will actually bond. We also run a moisture scan, because wet insulation under a TPO roof gets cut out before anything is coated.

Once coated, the roof has a new wearing surface and the seams are sealed under the coating film. TPO roof restoration in Minneapolis, MN is usually done with silicone roof coating on flat decks. Call (833) 441-4944 to book a roof survey.

How a coating job runs

Four steps to commercial roof coating in Minneapolis, MN

  1. 01

    Roof survey

    We walk the roof, photograph problem areas and run a moisture scan with core cuts where needed.

  2. 02

    Written scope

    You get the coating system, dry film thickness, repair list and wet insulation areas in writing.

  3. 03

    Prep and repairs

    Our crew cuts out wet areas, cleans the roof, seals seams and fasteners and primes where the substrate needs it.

  4. 04

    Coating applied

    The coating goes on in measured passes, checked with a wet-mil gauge, and we photo-document the finished roof.

Coverage

Commercial Roof Coating Across Minneapolis, MN

Commercial roof coating and silicone roof restoration for buildings across Minneapolis, MN.

Neighborhoods we cover for commercial roof coating

  • Downtown
  • Northeast
  • North Loop
  • Uptown
  • Powderhorn
  • Longfellow
  • Cedar-Riverside
  • Phillips
  • Camden
  • Near North
  • Southwest
  • University

ZIP codes we serve

55401 55402 55403 55404 55405 55406 55407 55408 55409 55410 55411 55412 55413 55414 55415 55416 55417 55418 55419 55420 55421 55422 55423 55424 55425 55426 55427 55428 55429 55430 55431 55432 55433 55434 55435 55436 55437 55438 55439 55441 55442 55443 55444 55445 55446 55447 55448 55449 55450 55454 55455

Commercial Roof Coating FAQs

Questions about commercial roof coating and silicone roof restoration

Questions we hear about TPO Roof Restoration in Minneapolis, MN.

Call our crew
What is a commercial roof coating?
A commercial roof coating is a fluid-applied membrane, usually silicone, acrylic or polyurethane, sprayed or rolled over an existing roof. It seals seams and small defects, adds a new UV-resistant surface and in most cases turns the roof white. It restores the roof you have instead of replacing it.
How long does silicone roof restoration last?
Coating systems are usually sold in thickness tiers, and thicker systems last longer before they need a recoat. Your manufacturer's data sheet is the honest source for expected life. The big advantage is that at the end of that period the roof is typically cleaned and recoated, not torn off.
Can you coat a roof that holds water?
Silicone tolerates ponding water better than other coatings, but water that sits for more than 48 hours should be dealt with. We can reset drains, add crickets or build slope before coating.
Do you need to shut down my building?
No. Coating work happens on the roof and the building stays closed. We phase the job around your hours and keep overspray and odor under control around air intakes.
What roof types can be coated?
We coat metal, TPO, EPDM, PVC, modified bitumen, built-up roofs and spray foam. Each needs its own cleaning and primer steps, and we run an adhesion test on your roof before committing.

Free commercial roof survey

Need Commercial Roof Coating in Minneapolis, MN? Call now.

Tell us about the roof. We will set a time for a survey and moisture check, then give you a written scope for commercial roof coating in Minneapolis, MN. Call (833) 441-4944.

(833) 441-4944
Phone · (833) 441-4944
Call (833) 441-4944 Enquire